RED: SUN BONNET

JUNE 19, 2012 BY DELIA 28 COMMENTS

The summer sun is not a friend to our little Natalie’s snow white skin. Since summer is the time to be out and about, I knew I needed something to protect her head that would be easy to lay her down on as well.

The obvious solution was a bonnet.

Doesn’t she look so sweet in it?

It is quite easy to make and takes just a little time and a little fabric.

Materials:
1/3 yard of fabric (you can mix and match with other patterns or solids or just use the same fabric throughout) this should be enough fabric for a bonnet up to about 9-12 months…I’m estimating.
1/8 yard of very thick, stiff interfacing
1/4 yard of 1/2 inch elastic

STEP ONE: Make a pattern.

Trace a hood from a jacket to get the size and shape you want. Then trace another line around that line about 1/4 inch larger.

Draw a brim. Make sure to make it about 1/2 inch wider than you want it to be for seam allowance.

Ta da…you have a pattern.

Now cut your pieces.

You’ll need:
2 each for each type of fabric in the main hat piece
2 strips for ties (about 1 1/2 inches by 18 inches which you’ll shorten later)
1 each for each type of fabric and the interfacing for the brim

Pin and sew the main hat pieces together and the brim piece…right sides facing.

Cut notches around the curved edges, being careful not to snip through any sewn lines.

Cut down the seam allowance for one of the hat pieces to reduce bulk.

Turn brim piece right side out and press. Cut interfacing down a bit to fit inside.

Take your main hat/bonnet pieces and fold it down so seams match up like in the picture. Measure in about an inch and draw a straight line. Sew on that line.

Then trim off the excess. I use pinking shears but this isn’t necessary.

Turn one of the hat pieces right side out. It should look like this at the back of the hat.

Iron the raw edges of the hat pieces inward. Stack them into each other.

Mark the center of the brim with a pin. Match the pin up with the seam of the main hat/bonnet pieces.

Sandwich the brim into the main bonnet pieces and pin.

Sew slow and careful along the folded edge of the main hat pieces. Be conscious that the under layer catches. Leave the folded edges not attached to the brim un-sewn.

You my have some shifting. I did.

Simply cut of some of the excess to even things out.

Now iron in in the bottom raw edges.

Sew all the way around twice, leaving about 5/8 of an inch between each sewn line. This creates a casing.

As you can see, there was more shifting, so I did some creative folding. I’ll make another and get it even yet! :)

Attach a safety pin or diaper pin to the elastic and thread it through the casing.

Stop about a half inch before you reach the other side. Sew two lines 1 inch from the other end.

Pull the elastic until you get the amount of gathering you desire. Then sew two lines about an inch in from the other side. Snip off the excess elastic.

Create the ties. You can sew a tube, turn it right side out, press and sew again. I chose to iron in the raw edges and sew.

Insert the ties into the one inch little nooks at the ends of the casing.

Sew them in matching the sewn lines from when you sewed the brim in.

Find the length you want your ties to be, knot the ends and trim off the excess.

And your sun bonnet is complete!

It’s even reversible if you decide it’s not a day for polka dots.

I am still trying to get the hang of using patterned fabric more intelligently.

Whenever I look at how poorly the dots are lined up I think of that Project Runway episode when Michael Kors remarks to one of the designers that the woman he was sewing for should be able to afford to have her dots lined up. :) haha